RC Helicopter Blade Balancing

RC Helicopter Blade Balancing

RC helicopter blade balancing is seen by some as art to be mastered completely by themselves and some people never really. Of course, there is the balancing of the rotor RC helicopter spend the tools you buy, but because if you do not need the money? Or if you balance your rotor blades and the tool does not need in the area? It 'possible that the blades, without an instrument of balance of compensation?

Yes, that's all!

This article is the layout of a free and very effective way for you to be ablestatically and dynamically balance your rotor blades. All you have to do is a bit 'of time and energy to do it well.

Some people have asked why even begin to balance the blades and the answer is very simple: eliminate unwanted vibration RC Helicopter. It 'a little' how to drive a car with a wheel out of balance - just throws out the entire trip. With RC helicopters, but throws out the flight, can seriously affect its flightPerformance and vibration that can occur apart your RC Helicopter!

The central idea of ​​balancing the rotor is to get rid of unwanted vibrations from time as possible. It may not be able to get rid of them all, so do not get upset if there is a small vibration to be desired.

The method that we use is effective and does not take long to accept everyone, but it is important that you do it with care and precision. If everything is done, you have knives that are static anddynamically balanced.

This is what is needed - the main rotor blades, a round shank (Market, main shaft, etc..) Of any kind, a sharp pencil, or balance, electrical tape, wire and a screw.

How do you balance the blades, dynamically

1 First, we want to see that attention is the same for each sheet. Here's how I do it:

2 point round the tree on a flat surface.

3 Insert a rotor blade on top of the well rounded, balancingPush with your fingers to find the blade back and forth until (also known as the center of gravity), their compensation for land.

4 Now, mark this point with a pencil and move the blade as they choose.

5 Do this with the second blade as well.

6 Now adjust the blade on the other.

7 Move the blade more than enough to see where the balance point is for them and compare the two points.

8 If they are separated by more than 1 mm, it is necessary to modifyBalance on the blade, which will focus on the next blade tip, transferring the budget is closer to the screw hole. You can do this by adding small strips near the bolt hole to fit the points of focus on both blades

9 Repeat this process until you have applied enough tape to make the correction needed to adjust to gravity (balance point) of the two blades and you're done!

How do you balance the blades static

This type ofBalance is the weight of each blade, the other, and this is how we do it:

1 Take a screw and connect the leaves and put them aside as they would be symmetrical on the run.

2 Hang the blades by the thread. You can do this with a wing nut or just the upper thread between the blade and the nut before tightening together. So make sure the wire in a row with the center of the leaves or you just wasted your time. You can alsoCenter between the ends of the bold two objects at the same height (as a 2 of 4) to compensate.

3 Pick up the thread and let the blades of course. Look at eye level to see if they are on or when a rotor blade is lower than the other. If they are, then job well done! If you are not level, then we have by adding small strips of masking tape on the blade, which is higher (yes, it's easier) to fix.

The key is to add the strips near the point of balance, orFocus, so as not to undo all the work already done. Just insert the tape until they are both at level and if they are, we know that they are balanced! You are now an official RC Helicopter Blade Balancing-guru! Well done!

kitchen aid dishwasher